Installation Notes:

This software is designed to run under Windows XP/2003/Vista/7 only. It must be installed under the account (user) that will be normally used to run the software. This account must have administrative rights during installation, but these right are not necessary during normal operation. Listed below are specific installation instructions. Failure to follow these instructions will most likely result in a failed installation or errors during operation.

For Windows XP, and 2003 you have two choices:

1. Install and run the software under a user account that has administrative rights. This is not recommended, but involves few extra steps.

2. Create a user to run Virtual DJ. For this example, assume you have will create a user named "Radio."

a. Open Control Panel and then User Accounts.
b. Under "Related Tasks," choose to "Create a New Account."
c. Type the name "Radio" for the account and click "Next."
d. Under "Choose an Account Type," choose "Computer administrator." Then click "Create Account."
e. Close "User Accounts."
f. Insert the CDROM and if the setup program does not start automatically, find "Setup.exe" or "Setup" on the CDROM and double-click it.
g. Enter the following information to activate your software:

Name: <Your Name>
Registration Code: <Your Reg Code>

(This information will be provided by your vendor.)

h. Follow the directions and install the software.
i. Open Control Panel again and User Accounts.
j. Choose "Radio" and then choose "Change account type." Select "Limited User." Then click the "Change Account Type" button.
h. Close User Accounts.

For Windows Vista and Windows 7, the procedure is slightly different.

Follow the same steps, except when actually installing the software. Because Windows Vista limits the rights of all computer administrators, you must cancel any automatic installion and then find the "Setup.exe" or "Setup" on the CDROM. Do not double-click on it, but rather right-click and choose "Run as Administrator." Then follow all the same steps.

Please read the manual completely before attempting to setup the software. It may take a few tries and a bit of experimentation to get the hang of it, even if you have used automation software before.

Please do not contact your vendor with technical questions as they are not able to help you. Instead contact me at hswear3@swbell.net or call 870-780-6679 between 10 AM and 10 PM CDT. I will be happy to talk you through any difficulties.



Herbert N Swearengen III
Software Developer

